How To Flash Stock Firmware Xiaomi With MI Flash Tool

How To Flash Stock Firmware Xiaomi With MI Flash Tool - October 1, 2022

For some reason, you may want to completely re-install the firmware on your Xiaomi phone. While updating the Xiaomi ROM is simply a one-tap action through the Over The Air (OTA) Update mechanism,

Reinstalling a full Xiaomi firmware which in this case is stock MIUI ROM is not that simple. It requires a series of steps that are basically not newbie-friendly.

How To Flash Xiaomi With MI Flash Tool

Therefore, here is a full step-by-step guide on how to properly flash Xiaomi ROM on any using the Mi Flash tool. We will try to simplify all the steps so you will not be too confused.

Simply follow all mentioned steps accordingly and you should be good to go. This guide works on Windows 7, 8, 8.1, and 10. It is also applicable to any series of Xiaomi phones from Mi.

The Advantages Of Firmware:

You Can Use The Xiaomi Stock ROM For Upgrade or Downgrade Xiaomi And If You Want To Hard Reset It By Flashing The Xiaomi Stock ROM / In Case You Are Using Any Custom Rom And Want Back To Stock Rom Or Facing The Boot Loop Problem.

  • Unroot or Fix Bugs on the phone
  • To solve the lag or stutter on Xiaomi
  • Revert to stock to get your warranty.

Pre-Requirements To Flash Xiaomi Stock ROM:

  • Supported Phone: Xiaomi
  • Charge your mobile: You may no less than a half charge.
  • Laptop or PC: To execute this installation, you must use a PC or Laptop.
  • Xiaomi USB Drivers: Under Mi Flash Tool Installation Folder.
  • Xiaomi Mi Flash Tool: Download Xiaomi Mi Flash Tool Latest version

Instructions To Install Xiaomi Stock Firmware File:

1: First of all, download the Xiaomi MI Flash Tool on your computer and then extract it.

2: Now you have to open the Setup File (MiFlash20170425.msi) and install Xiaomi MI Flash Tool on your computer.

3: Next you have to Download “ Xiaomi Stock Firmware” from the above-given link for your Xiaomi Phone and then you have to extract it on your computer.

4: Now you have to switch off your Xiaomi Phone. After switching off the phone, it has to be Turn On in the Download Mode (Fastboot).

To turn on the Download mode, you have to press Volume Down and Power Button together for 5 seconds.

5: Once your Phone is turned on in Download Mode, you will see something like this on the screen.

How To Flash Stock Firmware Xiaomi With MI Flash Tool - October 1, 2022

6: Now you have to connect your Xiaomi phone to a computer with the help of an original USB cable.

7: Now open the Xiaomi MI Flash tool.

8: Now you have to click on the Select button and locate the Xiaomi Firmware Folder.

9: Once your Xiaomi Firmware is loaded then you have to click on the Flash button to start Flashing Process.

10: After the flashing process starts, you will have to wait for 10-15 minutes and as soon as your flashing is completed you will see Green Success Massage in Xiaomi Mi Flash Tool.

Conclusion:

The first start is very slow, but it’s normal. It may take a few minutes before the Android operating system shows the configuration screen. If something goes wrong or the phone doesn’t boot up after a significant amount of time, restart again and try flashing Xiaomi Firmware again. Also, make sure you have downloaded the correct Xiaomi ROM file.

That’s all. If you encounter problems during the flashing ROM procedure on Android phones, please do not hesitate to contact us via the comments at the end of this article.

Leave a Reply

Your email address will not be published.